These tiles need to be stuck to the ground as they don't connect to each other. Adhesive available separately.
Rubber Square Playground Tiles 50cm x 50cm x 20mm
These rubber tiles can be used in severe conditions due to their high durability. They retain their shape and characteristics for years without any change. Weather conditions (cold, warm, humid etc.) do not change the shape.
These products are durable, lightweight and also have a high shock absorption, slip resistance to prevent injuries. The surface of the tile prevents people's fatigue.
These tiles are lighter than other material and significantly less expensive.
Rubber tiles are adhered to the floor with our XP2435 PU Adhesive (not included)
Tile Size: 50cm x50cm x 20cm (30mm and 40mm thickness also available.)
Stops Moisture's Resistance to abrasions
Contains UV particles for outside climate conditions
Inspect delivered rubber tiles thoroughly. Any visual defects must be reported prior to installation.
Store tiles and adhesive in clean, dry, protected from direct sunlight environment at a minimum temperature of 5°C.
Read installation instructions, warranty and other disclaimers before beginning any installations.
All subfloors must be inspected prior to installation;
Suitable subfloors: Concrete, Asphalt, Wood, Existing flooring – linoleum or vinyl (as long as it is completely adhered to the subfloor)
All subfloors must be free from structural defects, smooth, clean, dry and flat; All subfloors must be free of moisture, dust, sealers, paint, primers, curing compounds, parting agents, adhesive removers, hardeners, as well as any solvents, wax, oil, grease, asphalt, gypsum compounds, salts, mould, mildew, or any other materials that may inhibit good adhesion;
All subfloors must have a gradient (2% is suggested) to ensure adequate drainage;
The moisture in the subfloor shall not exceed 4 % and the temperature of the subfloor shall be between 5°C and 30 °C;
Always install tiles in favourable weather conditions: Temperatures between +10°C; and +30°C, Relative Air Humidity not exceeding 65 %.
If the subfloor does not meet the above-noted requirements, the tiles shall not be installeduntil the problem has been corrected!
*** It is buyer's responsibility to make sure all surfaces are in suitable condition to ensure good adhesion. ***
Determine Your Layout
Dry Lay rubber tiles so that you have a good idea of what the flooring will look like and to choose your starting place. We recommend laying tiles using a brick – bond pattern in which tiles are staggered in alternating rows to provide long – term stability. To achieve the recommended “brick” pattern, it may be necessary to cut the first and last tiles.
Our XP2435 PU Adhesive has been specially formulated to adhere our Rubber Tiles to almost any surface including concrete, asphalt and timber.
As rubber tiles have a high thermal coefficient of expansion we have developed a flexible PU adhesive to adhere our Rubber Tiles. This results in an effective and practical fixing method which can be used in damp and humid conditions.
XP 2435 PU adhesive is supplied in 1 litre bottles with nozzle. The adhesive is applied by simply cutting the nozzle to get a 3-4mm bead. Please click on the links below for the printable XP 2435 PU adhesive data sheet. For safety precautions see container label or data sheet. XP 2435 PU Adhesive Data Sheet 1 Litre - XP 2435 PU Adhesive
Always wear gloves.
Let the Floor Cure
Do no place playground equipment, furniture.
Allow traffic or institute general cleaning procedure 48 hours after installation.
Disclaimer: Generally accepted installation practices should be followed. Use of trained installation professionals is recommended for best results. Active Garden Ltd does not warrant any installation work and specifically disclaims liability for any direct or indirect personal injury, property damage or other costs or losses resulting from incorrect or inadequate installations.